To support the NT35510 display, some additional
options needs to be configurable in the STM32
DSI peripheral
Signed-off-by: Erik Andersson <erian747@gmail.com>
Allows device tree to enable usage of the controller feature
where HS clock is disabled when not in use, which is good
for reducing power consumption if MIPI DSI is mostly idle.
Signed-off-by: Mike J. Chen <mjchen@google.com>
Only setup DPI input from LCDIF if MODE_VIDEO is set, as this
is the the only case where input from the LCDIF would be required to
drive the display. Do not populate the dpi_config structure unless a
reference the the NXP LCDIF device is provided, since this is the output
device providing DPI data.
Signed-off-by: Daniel DeGrasse <daniel.degrasse@nxp.com>
Make DPI mode an optional configuration for the DSI MCUX 2L driver.
DPI mode will only be enabled when the MIPI is attached in video mode,
since this is when DPI formatted packets are expected.
This will enable the DSI driver to also support DBI/command mode, for
displays that use this format.
Signed-off-by: Daniel DeGrasse <daniel.degrasse@nxp.com>
Introduce phy-clock property, which is used by MIPI devices to determine
the target clock frequency for the MIPI PHY. This property can vary
depending on the attached display and target framerate.
Update the MIPI DSI MCUX driver to utilize this property to configure
the MIPI host, and update the RT500 clock initialization to configure
the MIPI root clock based on this property.
Remove dphy-clk-div property from the MIPI DSI 2L binding, as it
is redundant with this change.
Signed-off-by: Daniel DeGrasse <daniel.degrasse@nxp.com>
Introduce driver for MCUX MIPI DSI 2L. This IP block differs slightly from
the existing MCUX MIPI peripheral, and uses a different hardware
abstraction layer. For these reasons, a new driver was introduced rather
than extending the existing mcux_dsi implementation.
Signed-off-by: Daniel DeGrasse <daniel.degrasse@nxp.com>
All in tree device drivers on a bus use some form of DEVICE_DT_GET
so we no longer need to require label properties.
Signed-off-by: Kumar Gala <galak@kernel.org>
