Some radio drivers need configuration before start-up. Up to now only
the RF2XX drivers allowed this, but other radio drivers need this as
well. In particular for setting EUI64 addresses.
Signed-off-by: Markus Becker <markus.becker@tridonic.com>
Add a Kconfig option that allows user to set any necessary config
using management interface before interface be operational. A use
case is set the EUI-64 address from an external EEPROM by the
NET_REQUEST_IEEE802154_SET_EXT_ADDR command. After all configs
are done net_if_up() can be invoked to bring interface up.
Fixes#23193.
Signed-off-by: Gerson Fernando Budke <nandojve@gmail.com>
The rf2xx driver needs GPIO driver to works. The RST, SLPTR and INT
are mandatory signals and driver uses DT to configure them. This add
the GPIO dependency on Kconfig.rf2xx file.
Signed-off-by: Gerson Fernando Budke <nandojve@gmail.com>
Same deal as in commit bd6e04411e ("kconfig: Clean up header comments
and make them consistent") and commit 1f38ea77ba ("kconfig: Clean up
'config FOO' (two spaces) definitions"), for some newly-introduced
stuff.
Signed-off-by: Ulf Magnusson <Ulf.Magnusson@nordicsemi.no>
Add initial Atmel at86rf2xx transceiver driver. This driver uses device
tree to configure the physical interface. The driver had capability to
use multiple transceiver and systems with multiple bands can be used.
With this, 2.4GHz ISM and Sub-Giga can be used simultaneous.
Below a valid DT example. This samples assume same SPI port with two
transceivers.
&spi0 {
status = "okay";
label = "SPI_RF2XX";
cs-gpios = <&porta 31 0 &porta 30 0>;
rf2xx@0 {
compatible = "atmel,rf2xx";
reg = <0x0>;
label = "RF2XX_0";
spi-max-frequency = <7800000>;
irq-gpios = <&portb 2 0>;
reset-gpios = <&porta 3 0>;
slptr-gpios = <&portb 3 0>;
status = "okay";
};
rf2xx@1 {
compatible = "atmel,rf2xx";
reg = <0x1>;
label = "RF2XX_1";
spi-max-frequency = <7800000>;
irq-gpios = <&portb 4 0>;
reset-gpios = <&porta 4 0>;
slptr-gpios = <&portb 4 0>;
status = "okay";
};
};
At the moment driver assume two transceiver are enouth for majority of
appications. Sub-Giga band will be enabled in future.
Signed-off-by: Gerson Fernando Budke <nandojve@gmail.com>
