Use '0xa0' as default priority to be consistent with the V1/V2 and
V3 drivers default priority init.
Signed-off-by: Sandeep Tripathy <sandeep.tripathy@broadcom.com>
For HPET devices, configure it with fixed delivery mode because HPET
timer interrupt is needed to fuel the scheduler for all CPUS.
For all other type of devices, like UART, I2C, GPIO, Ethernet, etc.
configure them as lowest priority delivery mode, in which IO APIC
delivers the interrupt to the processor core that is executing at the
lowest priority among all the processors listed in the specified
destination. In this case, the device drivers can avoid the trouble of
handling repeated interrupts delivered to all CPUS.
Signed-off-by: Zide Chen <zide.chen@intel.com>
The GIC-400 driver currently only supports SPIs because the (32) offset
for the INTIDs is hard-coded in the driver. At the driver level there is
no really difference between PPIs and SPIs so we can easily extend the
driver to support PPIs as well.
This is useful if we want to add support for the ARM Generic Timers that
use INTIDs in the PPI range.
SPI interrupts are in the range [0-987]. PPI interrupts are in the range
[0-15].
This commit adds interrupt 'type' cell to the GIC device tree binding
and changes the 'irq' cell to use interrupt type-specific index, rather
than a linear IRQ number.
The 'type'+'irq (index)' combo is automatically fixed up into a linear
IRQ number by the scripts/dts/gen_defines.py script.
Signed-off-by: Stephanos Ioannidis <root@stephanos.io>
Signed-off-by: Carlo Caione <ccaione@baylibre.com>
Remove the handcoded multi-level IRQ values in device tree. We now are
able to generate the encoded multi-level IRQ value.
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
The GIC400 is a common interrupt controller that can be used with the
Cortex A and R series processors. This patch adds basic interrupt
handling for the GIC, but does not handle multiple routing or
priorities.
Signed-off-by: Bradley Bolen <bbolen@lexmark.com>
Add a level 2 interrupt controller for the RV32M1 SoC. This uses the
INTMUX peripheral.
As a first customer, convert the timer driver over to using this,
adding nodes for the LPTMR peripherals. This lets users select the
timer instance they want to use, and what intmux channel they want to
route its interrupt to, using DT overlays.
Signed-off-by: Marti Bolivar <marti@foundries.io>
Signed-off-by: Mike Scott <mike@foundries.io>
Any word started with underscore followed by and uppercase letter or a
second underscore is a reserved word according with C99.
Signed-off-by: Flavio Ceolin <flavio.ceolin@intel.com>
