From fda588bf1a5df6b840e3b13311298e8d7df1a19f Mon Sep 17 00:00:00 2001 From: "The.Thanh Nguyen" Date: Sat, 22 Mar 2025 13:30:53 +0700 Subject: [PATCH] boards: shields: rtkmipilcdb00000be: update shield doc Correct doc formatting Remove platform specific hardware configuration Signed-off-by: The.Thanh Nguyen --- .../shields/rtkmipilcdb00000be/doc/index.rst | 27 +++++-------------- 1 file changed, 7 insertions(+), 20 deletions(-) diff --git a/boards/shields/rtkmipilcdb00000be/doc/index.rst b/boards/shields/rtkmipilcdb00000be/doc/index.rst index 4e77512e6d5..301a793382d 100644 --- a/boards/shields/rtkmipilcdb00000be/doc/index.rst +++ b/boards/shields/rtkmipilcdb00000be/doc/index.rst @@ -14,19 +14,19 @@ This display uses a 26 pin connector header. Pins Assignment of the Renesas RTKMIPILCDB00000BE MIPI Display ============================================================== -+-----------------------+------------------------+ ++----------------------+-------------------------+ | Connector Pin | Function | -+=======================+========================+ ++======================+=========================+ | 14 | Touch ctrl I2C SDA | -+-----------------------+------------------------+ ++----------------------+-------------------------+ | 15 | Display backlight enable| -+-----------------------+------------------------+ ++----------------------+-------------------------+ | 16 | Touch ctrl I2C SCL | -+-----------------------+------------------------+ ++----------------------+-------------------------+ | 17 | External interrupt | -+-----------------------+------------------------+ ++----------------------+-------------------------+ | 18 | Display reset | -+-----------------------+------------------------+ ++----------------------+-------------------------+ Hardware Requirements: ********************** @@ -35,19 +35,6 @@ Supported Renesas RA boards: EK-RA8D1 - 1 x RA Board - 1 x Micro USB cable -Hardware Configuration: -*********************** - -The MIPI Graphics Expansion Port (J58) connects the EK-RA8D1 board to the MIPI Graphics Expansion Board -supplied as part of the kit. - -Set the configuration switches (SW1) as below to avoid potential failures. - +-------------+-------------+--------------+------------+------------+------------+-------------+-----------+ - | SW1-1 PMOD1 | SW1-2 TRACE | SW1-3 CAMERA | SW1-4 ETHA | SW1-5 ETHB | SW1-6 GLCD | SW1-7 SDRAM | SW1-8 I3C | - +-------------+-------------+--------------+------------+------------+------------+-------------+-----------+ - | OFF | OFF | OFF | OFF | OFF | ON | ON | OFF | - +-------------+-------------+--------------+------------+------------+------------+-------------+-----------+ - Programming ***********