drivers: flash: stm32 xspi: early init exit for memmap mode
Exit the init earlier when XSPI is in memory map mode. Avoid unnecessary checks and prevent pin reconfiguration that might cause line spikes. Clock check beforehand is preserved. Remove '\n' from the LOG_DBG string. Signed-off-by: Georgij Cernysiov <geo.cgv@gmail.com>
This commit is contained in:
parent
9040dee5ef
commit
db28dbd888
1 changed files with 15 additions and 15 deletions
|
@ -2019,6 +2019,21 @@ static int flash_stm32_xspi_init(const struct device *dev)
|
|||
uint32_t prescaler = STM32_XSPI_CLOCK_PRESCALER_MIN;
|
||||
int ret;
|
||||
|
||||
if (!device_is_ready(DEVICE_DT_GET(STM32_CLOCK_CONTROL_NODE))) {
|
||||
LOG_ERR("clock control device not ready");
|
||||
return -ENODEV;
|
||||
}
|
||||
|
||||
#ifdef CONFIG_STM32_MEMMAP
|
||||
/* If MemoryMapped then configure skip init */
|
||||
if (stm32_xspi_is_memorymap(dev)) {
|
||||
LOG_DBG("NOR init'd in MemMapped mode");
|
||||
/* Force HAL instance in correct state */
|
||||
dev_data->hxspi.State = HAL_XSPI_STATE_BUSY_MEM_MAPPED;
|
||||
return 0;
|
||||
}
|
||||
#endif /* CONFIG_STM32_MEMMAP */
|
||||
|
||||
/* The SPI/DTR is not a valid config of data_mode/data_rate according to the DTS */
|
||||
if ((dev_cfg->data_mode != XSPI_OCTO_MODE)
|
||||
&& (dev_cfg->data_rate == XSPI_DTR_TRANSFER)) {
|
||||
|
@ -2034,21 +2049,6 @@ static int flash_stm32_xspi_init(const struct device *dev)
|
|||
return ret;
|
||||
}
|
||||
|
||||
if (!device_is_ready(DEVICE_DT_GET(STM32_CLOCK_CONTROL_NODE))) {
|
||||
LOG_ERR("clock control device not ready");
|
||||
return -ENODEV;
|
||||
}
|
||||
|
||||
#ifdef CONFIG_STM32_MEMMAP
|
||||
/* If MemoryMapped then configure skip init */
|
||||
if (stm32_xspi_is_memorymap(dev)) {
|
||||
LOG_DBG("NOR init'd in MemMapped mode\n");
|
||||
/* Force HAL instance in correct state */
|
||||
dev_data->hxspi.State = HAL_XSPI_STATE_BUSY_MEM_MAPPED;
|
||||
return 0;
|
||||
}
|
||||
#endif /* CONFIG_STM32_MEMMAP */
|
||||
|
||||
if (dev_cfg->pclk_len > 3) {
|
||||
/* Max 3 domain clock are expected */
|
||||
LOG_ERR("Could not select %d XSPI domain clock", dev_cfg->pclk_len);
|
||||
|
|
Loading…
Add table
Add a link
Reference in a new issue