michaelh/zephyr
1
0
Fork 0
Code Releases Activity

doc: release,migration-notes/3.7: add bits for serial

Browse source 
This adds some bits about serial drivers.

Signed-off-by: Daniel Leung <daniel.leung@intel.com>
This commit is contained in:
Daniel Leung 2024-07-02 11:02:24 -07:00 • committed by Alberto Escolar
commit b118da62b8
2 changed files with 70 additions and 0 deletions
Download patch file Download diff file Expand all files Collapse all files

3
doc/releases/migration-guide-3.7.rst
View file

@ -659,6 +659,9 @@ Sensors
Serial
======
* The Raspberry Pi UART driver ``uart_rpi_pico`` has been removed.
Use ``uart_pl011`` (:dtcompatible:`arm,pl011`) instead. (:github:`71074`)
Timer
=====

67
doc/releases/release-notes-3.7.rst
View file

@ -602,6 +602,73 @@ Drivers and Sensors
enables using Bluetooth as a transport to all the subsystems that are currently supported by
UART (e.g: Console, Shell, Logging).
* Added support for HSCIF (High Speed Serial Communication Interface with FIFO) in the UART
driver for Renesas RCar platforms.
* Added driver for ENE KB1200 UART.
* Added driver for UART on Analog Devices MAX32 series microcontrollers.
* Added driver for UART on Renesas RA8 devices.
* ``uart_emul`` (:dtcompatible:`zephyr,uart-emul`):
* Added support for asynchronous API for the emulated UART driver.
* ``uart_esp32`` (:dtcompatible:`espressif,esp32-uart`):
* Added support to invert TX and RX pin signals.
* Added support for ESP32C6 SoC.
* ``uart_native_tty`` (:dtcompatible:`zephyr,native-tty-uart`):
* Added support to emulate interrupt driven UART.
* ``uart_mcux_lpuart`` (:dtcompatible:`nxp,kinetis-lpuart`):
* Added support for single wire half-duplex communication.
* Added support to invert TX and RX pin signals.
* ``uart_npcx`` (:dtcompatible:`nuvoton,npcx-uart`):
* Added support for asynchronous API.
* Added support for baud rate of 3MHz.
* ``uart_nrfx_uarte`` (:dtcompatible:`nordic,nrf-uarte`):
* Added support to put TX and RX pins into low power mode when UART is not active.
* ``uart_nrfx_uarte2`` (:dtcompatible:`nordic,nrf-uarte`):
* Prevents UART from transmitting when device is suspended.
* Fixed some events not being triggered.
* ``uart_pl011`` (:dtcompatible:`arm,pl011`):
* Added support for runtime configuration.
* Added support for reset device.
* Added support to use clock control to determine frequency.
* Added support for hardware flow control.
* Added support for UART on Ambiq Apollo3 SoC.
* ``uart_smartbond`` (:dtcompatible:`renesas,smartbond-uart`):
* Added support for power management.
* Added support to wake up via DTR and RX lines.
* ``uart_stm32`` (:dtcompatible:`st,stm32-uart`):
* Added support to identify if DMA buffers are in data cache or non-cacheable memory.
* SPI
* Added support for Ambiq Apollo3 series general IOM based SPI.