diff --git a/boards/arm/stm3210c_eval/stm3210c_eval.dts b/boards/arm/stm3210c_eval/stm3210c_eval.dts
index d540a972d9a..baa0b2359b4 100644
--- a/boards/arm/stm3210c_eval/stm3210c_eval.dts
+++ b/boards/arm/stm3210c_eval/stm3210c_eval.dts
@@ -41,6 +41,27 @@
 	};
 };
 
+&clk_hse {
+	hse-bypass;
+	clock-frequency = <DT_FREQ_M(8)>; /* STLink 8MHz clock */
+	status = "okay";
+};
+
+&pll {
+	mul = <9>;
+	prediv = <1>;
+	clocks = <&clk_hse>;
+	status = "okay";
+};
+
+&rcc {
+	clocks = <&pll>;
+	clock-frequency = <DT_FREQ_M(72)>;
+	ahb-prescaler = <1>;
+	apb1-prescaler = <2>;
+	apb2-prescaler = <1>;
+};
+
 &usart2 {
 	pinctrl-0 = <&usart2_tx_pd5 &usart2_rx_pd6>;
 	current-speed = <115200>;
diff --git a/boards/arm/stm3210c_eval/stm3210c_eval_defconfig b/boards/arm/stm3210c_eval/stm3210c_eval_defconfig
index 0793419d53b..d9d84620bf4 100644
--- a/boards/arm/stm3210c_eval/stm3210c_eval_defconfig
+++ b/boards/arm/stm3210c_eval/stm3210c_eval_defconfig
@@ -6,10 +6,6 @@ CONFIG_SOC_SERIES_STM32F1X=y
 # Platform Configuration
 CONFIG_SOC_STM32F107XC=y
 
-# General Kernel Options
-# 72MHz system clock
-CONFIG_SYS_CLOCK_HW_CYCLES_PER_SEC=72000000
-
 # Serial Drivers
 CONFIG_SERIAL=y
 CONFIG_UART_INTERRUPT_DRIVEN=y
@@ -23,21 +19,5 @@ CONFIG_PINMUX=y
 # GPIO Controller
 CONFIG_GPIO=y
 
-# RCC configuration
+# RCC Controller
 CONFIG_CLOCK_CONTROL=y
-# Clock configuration for Cube Clock control driver
-CONFIG_CLOCK_STM32_HSE_CLOCK=8000000
-CONFIG_CLOCK_STM32_SYSCLK_SRC_PLL=y
-# use HSE as PLL input
-CONFIG_CLOCK_STM32_PLL_SRC_HSE=y
-CONFIG_CLOCK_STM32_PLL_SRC_PLL2=n
-# however, the board does not have an external oscillator, so just use
-# the 8MHz clock signal coming from integrated STLink
-CONFIG_CLOCK_STM32_HSE_BYPASS=y
-# produce 72MHz clock at PLL output
-CONFIG_CLOCK_STM32_PLL_PREDIV1=1
-CONFIG_CLOCK_STM32_PLL_MULTIPLIER=9
-CONFIG_CLOCK_STM32_AHB_PRESCALER=1
-# APB1 clock must not to exceed 36MHz limit
-CONFIG_CLOCK_STM32_APB1_PRESCALER=2
-CONFIG_CLOCK_STM32_APB2_PRESCALER=1