57 lines
1.4 KiB
YAML
57 lines
1.4 KiB
YAML
|
# Copyright (c) 2019 Manivannan Sadhasivam
|
||
|
# Copyright (c) 2020 Andreas Sandberg
|
||
|
# SPDX-License-Identifier: Apache-2.0
|
||
|
|
||
|
include: spi-device.yaml
|
||
|
|
||
|
properties:
|
||
|
reset-gpios:
|
||
|
type: phandle-array
|
||
|
required: true
|
||
|
description: |
|
||
|
GPIO connected to the modem's NRST signal.
|
||
|
|
||
|
This signal is open-drain, active-low as interpreted by the
|
||
|
modem.
|
||
|
|
||
|
busy-gpios:
|
||
|
type: phandle-array
|
||
|
required: true
|
||
|
description: |
|
||
|
GPIO connected to the modem's BUSY signal.
|
||
|
|
||
|
antenna-enable-gpios:
|
||
|
type: phandle-array
|
||
|
required: false
|
||
|
description: |
|
||
|
Antenna power enable pin.
|
||
|
|
||
|
dio1-gpios:
|
||
|
type: phandle-array
|
||
|
required: true
|
||
|
description: |
|
||
|
GPIO connected to DIO1. This GPIO will be used as a generic
|
||
|
IRQ line from the chip.
|
||
|
|
||
|
dio2-tx-enable:
|
||
|
type: boolean
|
||
|
required: false
|
||
|
description: |
|
||
|
Use DIO2 to drive an RF switch selecting between the TX and RX
|
||
|
paths. When enabled, DIO2 goes high when the chip is
|
||
|
transmitting.
|
||
|
|
||
|
dio3-tcxo-voltage:
|
||
|
type: int
|
||
|
required: false
|
||
|
description: |
|
||
|
TCXO supply voltage controlled by DIO3 if present.
|
||
|
|
||
|
See constants in dt-bindings/lora/sx126x.h.
|
||
|
|
||
|
tcxo-power-startup-delay-ms:
|
||
|
type: int
|
||
|
required: false
|
||
|
description: |
|
||
|
Startup delay to let the TCXO stabilize after TCXO power on.
|