zephyr/samples/drivers/w1/scanner/ds2485.overlay

&arduino_i2c {
	status = "okay";

	w1: w1@40 {
		compatible = "maxim,ds2485";
		reg = <0x40>;
		switching-threshold = "medium";
		active-pull-threshold = "low";
		weak-pullup = "1000";
	};
};
samples/drivers/w1: scanner: add ds2485 overlay Adds an overlay for the ds2485 and adds a test configuration for it. Signed-off-by: Thomas Stranger <thomas.stranger@outlook.com> 2022-07-31 14:08:32 +02:00			`&arduino_i2c {`
samples: drivers: w1: Enable arduino_i2c and arduino_serial explicitly This sample uses the arduino_i2c and arduino_serial DT nodes, so it should enable them explicitly, not assume they will be enabled by default for a given board. Signed-off-by: Andrzej Głąbek <andrzej.glabek@nordicsemi.no> 2023-01-12 16:33:03 +01:00			`status = "okay";`

samples/drivers/w1: scanner: add ds2485 overlay Adds an overlay for the ds2485 and adds a test configuration for it. Signed-off-by: Thomas Stranger <thomas.stranger@outlook.com> 2022-07-31 14:08:32 +02:00			`w1: w1@40 {`
			`compatible = "maxim,ds2485";`
			`reg = <0x40>;`
			`switching-threshold = "medium";`
			`active-pull-threshold = "low";`
			`weak-pullup = "1000";`
			`};`
			`};`